Heat Load Calculator

Preliminary air conditioning heat load estimate for your space.

Free tool · Preliminary estimate

Air conditioning heat load calculator

Planning a fit-out, refurbishment or new building? Get an indicative cooling load, outdoor air requirement and system size in under a minute — built on Australian HVAC design principles.

  • Cooling load (kW)
  • Outdoor air (L/s)
  • Suggested system size
  • Confidence rating
Start the calculator
01

Describe your building

Location, building type, floor area, construction, glazing and how the space is used.

02

We apply HVAC design factors

Fabric and solar gains, people, equipment and outdoor air load using state design conditions.

03

Get a budget-ready estimate

Use it for early budgeting and concept planning, then talk to Enginova for the detailed design.

What the estimate covers

  • Peak sensible and latent cooling load
  • Building fabric, solar and lighting gains
  • Occupant and equipment heat gains
  • Outdoor air by occupancy or floor area, with IAQ level
  • Indicative supply air and system size range

What it does not cover

  • Heating loads and hour-by-hour analysis
  • Zoning, diversity and part-load operation
  • Detailed glazing, shading and façade performance
  • AS 1668.2 ventilation design and NCC Section J compliance
  • Equipment selection, ductwork and acoustics

Frequently asked questions

How accurate is the estimate?

It is a preliminary, rule-of-thumb estimate based on the information you enter and typical Australian commercial assumptions. Actual loads depend on façade detail, glazing specification, shading, zoning, diversity and operating hours, so a detailed calculation can differ materially. Use the result for budgeting and early planning only.

How is the outdoor air (ventilation) worked out?

The minimum outdoor air is taken as the greater of a per-person rate and a per-square-metre rate for the building type, then multiplied by the indoor air quality level you choose: Minimum Code (×1.0), Enhanced (×1.2) or Premium (×1.4). Final ventilation design must be carried out to AS 1668.2 by a qualified engineer.

What if I do not know the number of occupants?

Leave it blank. The calculator estimates occupancy from a typical floor area per person for the building type and lowers the confidence rating to reflect the assumption.

Can I use this to buy or select equipment?

No. The suggested size range is indicative only. Equipment selection needs a full heat load calculation, psychrometric analysis and consideration of part-load, humidity control, acoustics and NCC Section J energy efficiency requirements.

What does Enginova provide beyond this tool?

Enginova provides full HVAC heat load calculations, plant selection, ventilation design to AS 1668.2, NCC compliance assessments and Revit documentation for commercial, residential and mixed-use projects.

This tool provides a preliminary cooling load estimate only. Results are not a substitute for HVAC engineering design, NCC compliance assessment, AS1668.2 ventilation design, equipment selection or AIRAH heat load calculations.